diff options
| -rw-r--r-- | Documentation/admin-guide/kernel-parameters.txt | 20 | ||||
| -rw-r--r-- | Documentation/dev-tools/kgdb.rst | 24 |
2 files changed, 44 insertions, 0 deletions
diff --git a/Documentation/admin-guide/kernel-parameters.txt b/Documentation/admin-guide/kernel-parameters.txt index 7bc83f3d9bdf..2cbde9ea476d 100644 --- a/Documentation/admin-guide/kernel-parameters.txt +++ b/Documentation/admin-guide/kernel-parameters.txt @@ -1190,6 +1190,11 @@ This is designed to be used in conjunction with the boot argument: earlyprintk=vga + This parameter works in place of the kgdboc parameter + but can only be used if the backing tty is available + very early in the boot process. For early debugging + via a serial port see kgdboc_earlycon instead. + edd= [EDD] Format: {"off" | "on" | "skip[mbr]"} @@ -2105,6 +2110,21 @@ kms, kbd format: kms,kbd kms, kbd and serial format: kms,kbd,<ser_dev>[,baud] + kgdboc_earlycon= [KGDB,HW] + If the boot console provides the ability to read + characters and can work in polling mode, you can use + this parameter to tell kgdb to use it as a backend + until the normal console is registered. Intended to + be used together with the kgdboc parameter which + specifies the normal console to transition to. + + The name of the early console should be specified + as the value of this parameter. Note that the name of + the early console might be different than the tty + name passed to kgdboc. It's OK to leave the value + blank and the first boot console that implements + read() will be picked. + kgdbwait [KGDB] Stop kernel execution and enter the kernel debugger at the earliest opportunity. diff --git a/Documentation/dev-tools/kgdb.rst b/Documentation/dev-tools/kgdb.rst index d38be58f872a..61293f40bc6e 100644 --- a/Documentation/dev-tools/kgdb.rst +++ b/Documentation/dev-tools/kgdb.rst @@ -274,6 +274,30 @@ don't like this are to hack gdb to send the :kbd:`SysRq-G` for you as well as on the initial connect, or to use a debugger proxy that allows an unmodified gdb to do the debugging. +Kernel parameter: ``kgdboc_earlycon`` +------------------------------------- + +If you specify the kernel parameter ``kgdboc_earlycon`` and your serial +driver registers a boot console that supports polling (doesn't need +interrupts and implements a nonblocking read() function) kgdb will attempt +to work using the boot console until it can transition to the regular +tty driver specified by the ``kgdboc`` parameter. + +Normally there is only one boot console (especially that implements the +read() function) so just adding ``kgdboc_earlycon`` on its own is +sufficient to make this work. If you have more than one boot console you +can add the boot console's name to differentiate. Note that names that +are registered through the boot console layer and the tty layer are not +the same for the same port. + +For instance, on one board to be explicit you might do:: + + kgdboc_earlycon=qcom_geni kgdboc=ttyMSM0 + +If the only boot console on the device was "qcom_geni", you could simplify:: + + kgdboc_earlycon kgdboc=ttyMSM0 + Kernel parameter: ``kgdbwait`` ------------------------------ |