diff options
Diffstat (limited to 'Documentation/networking/bonding.rst')
| -rw-r--r-- | Documentation/networking/bonding.rst | 29 |
1 files changed, 22 insertions, 7 deletions
diff --git a/Documentation/networking/bonding.rst b/Documentation/networking/bonding.rst index 7823a069a903..e774b48de9f5 100644 --- a/Documentation/networking/bonding.rst +++ b/Documentation/networking/bonding.rst @@ -444,6 +444,18 @@ arp_missed_max The default value is 2, and the allowable range is 1 - 255. +coupled_control + + Specifies whether the LACP state machine's MUX in the 802.3ad mode + should have separate Collecting and Distributing states. + + This is by implementing the independent control state machine per + IEEE 802.1AX-2008 5.4.15 in addition to the existing coupled control + state machine. + + The default value is 1. This setting does not separate the Collecting + and Distributing states, maintaining the bond in coupled control. + downdelay Specifies the time, in milliseconds, to wait before disabling @@ -566,7 +578,8 @@ miimon link monitoring. A value of 100 is a good starting point. The use_carrier option, below, affects how the link state is determined. See the High Availability section for additional - information. The default value is 0. + information. The default value is 100 if arp_interval is not + set. min_links @@ -775,10 +788,11 @@ peer_notif_delay Specify the delay, in milliseconds, between each peer notification (gratuitous ARP and unsolicited IPv6 Neighbor Advertisement) when they are issued after a failover event. - This delay should be a multiple of the link monitor interval - (arp_interval or miimon, whichever is active). The default - value is 0 which means to match the value of the link monitor - interval. + This delay should be a multiple of the MII link monitor interval + (miimon). + + The valid range is 0 - 300000. The default value is 0, which means + to match the value of the MII link monitor interval. prio Slave priority. A higher number means higher priority. @@ -846,7 +860,7 @@ primary_reselect tlb_dynamic_lb Specifies if dynamic shuffling of flows is enabled in tlb - mode. The value has no effect on any other modes. + or alb mode. The value has no effect on any other modes. The default behavior of tlb mode is to shuffle active flows across slaves based on the load in that interval. This gives nice lb @@ -956,6 +970,7 @@ xmit_hash_policy hash = hash XOR source IP XOR destination IP hash = hash XOR (hash RSHIFT 16) hash = hash XOR (hash RSHIFT 8) + hash = hash RSHIFT 1 And then hash is reduced modulo slave count. If the protocol is IPv6 then the source and destination @@ -1633,7 +1648,7 @@ your init script:: ----------------------------------------- This section applies to distros which use /etc/network/interfaces file -to describe network interface configuration, most notably Debian and it's +to describe network interface configuration, most notably Debian and its derivatives. The ifup and ifdown commands on Debian don't support bonding out of |