diff options
Diffstat (limited to 'arch/arm64/boot/dts/freescale/imx8mm-verdin.dtsi')
-rw-r--r-- | arch/arm64/boot/dts/freescale/imx8mm-verdin.dtsi | 70 |
1 files changed, 43 insertions, 27 deletions
diff --git a/arch/arm64/boot/dts/freescale/imx8mm-verdin.dtsi b/arch/arm64/boot/dts/freescale/imx8mm-verdin.dtsi index d1b4582f44c4..6f0811587142 100644 --- a/arch/arm64/boot/dts/freescale/imx8mm-verdin.dtsi +++ b/arch/arm64/boot/dts/freescale/imx8mm-verdin.dtsi @@ -3,8 +3,8 @@ * Copyright 2022 Toradex */ -#include "dt-bindings/phy/phy-imx8-pcie.h" -#include "dt-bindings/pwm/pwm.h" +#include <dt-bindings/phy/phy-imx8-pcie.h> +#include <dt-bindings/pwm/pwm.h> #include "imx8mm.dtsi" / { @@ -32,10 +32,10 @@ }; /* Fixed clock dedicated to SPI CAN controller */ - clk20m: oscillator { + clk40m: oscillator { compatible = "fixed-clock"; #clock-cells = <0>; - clock-frequency = <20000000>; + clock-frequency = <40000000>; }; gpio-keys { @@ -53,6 +53,25 @@ }; }; + hdmi_connector: hdmi-connector { + compatible = "hdmi-connector"; + ddc-i2c-bus = <&i2c2>; + /* Verdin PWM_3_DSI (SODIMM 19) */ + hpd-gpios = <&gpio1 1 GPIO_ACTIVE_HIGH>; + label = "hdmi"; + pinctrl-names = "default"; + pinctrl-0 = <&pinctrl_pwm_3_dsi_hpd_gpio>; + type = "a"; + status = "disabled"; + }; + + panel_lvds: panel-lvds { + compatible = "panel-lvds"; + backlight = <&backlight>; + data-mapping = "vesa-24"; + status = "disabled"; + }; + /* Carrier Board Supplies */ reg_1p8v: regulator-1p8v { compatible = "regulator-fixed"; @@ -80,9 +99,10 @@ compatible = "regulator-fixed"; enable-active-high; gpio = <&gpio2 20 GPIO_ACTIVE_HIGH>; /* PMIC_EN_ETH */ - off-on-delay = <500000>; + off-on-delay-us = <500000>; pinctrl-names = "default"; pinctrl-0 = <&pinctrl_reg_eth>; + regulator-always-on; regulator-boot-on; regulator-max-microvolt = <3300000>; regulator-min-microvolt = <3300000>; @@ -119,7 +139,7 @@ enable-active-high; /* Verdin SD_1_PWR_EN (SODIMM 76) */ gpio = <&gpio3 5 GPIO_ACTIVE_HIGH>; - off-on-delay = <100000>; + off-on-delay-us = <100000>; pinctrl-names = "default"; pinctrl-0 = <&pinctrl_usdhc2_pwr_en>; regulator-max-microvolt = <3300000>; @@ -168,15 +188,15 @@ ddrc_opp_table: opp-table { compatible = "operating-points-v2"; - opp-25M { + opp-25000000 { opp-hz = /bits/ 64 <25000000>; }; - opp-100M { + opp-100000000 { opp-hz = /bits/ 64 <100000000>; }; - opp-750M { + opp-750000000 { opp-hz = /bits/ 64 <750000000>; }; }; @@ -202,8 +222,8 @@ can1: can@0 { compatible = "microchip,mcp251xfd"; - clocks = <&clk20m>; - interrupts-extended = <&gpio1 6 IRQ_TYPE_EDGE_FALLING>; + clocks = <&clk40m>; + interrupts-extended = <&gpio1 6 IRQ_TYPE_LEVEL_LOW>; pinctrl-names = "default"; pinctrl-0 = <&pinctrl_can1_int>; reg = <0>; @@ -343,7 +363,6 @@ pinctrl-names = "default"; pinctrl-0 = <&pinctrl_pmic>; reg = <0x25>; - sd-vsel-gpios = <&gpio1 4 GPIO_ACTIVE_HIGH>; /* * The bootloader is expected to switch on the I2C level shifter for the TLA2024 ADC @@ -367,8 +386,8 @@ nxp,dvs-standby-voltage = <850000>; regulator-always-on; regulator-boot-on; - regulator-max-microvolt = <950000>; - regulator-min-microvolt = <850000>; + regulator-max-microvolt = <1050000>; + regulator-min-microvolt = <805000>; regulator-name = "On-module +VDD_ARM (BUCK2)"; regulator-ramp-delay = <3125>; }; @@ -376,8 +395,8 @@ reg_vdd_dram: BUCK3 { regulator-always-on; regulator-boot-on; - regulator-max-microvolt = <950000>; - regulator-min-microvolt = <850000>; + regulator-max-microvolt = <1000000>; + regulator-min-microvolt = <805000>; regulator-name = "On-module +VDD_GPU_VPU_DDR (BUCK3)"; }; @@ -416,7 +435,7 @@ reg_vdd_snvs: LDO2 { regulator-always-on; regulator-boot-on; - regulator-max-microvolt = <900000>; + regulator-max-microvolt = <800000>; regulator-min-microvolt = <800000>; regulator-name = "On-module +V0.8_SNVS (LDO2)"; }; @@ -561,8 +580,8 @@ status = "disabled"; }; - lvds_ti_sn65dsi83: bridge@2c { - compatible = "ti,sn65dsi83"; + lvds_ti_sn65dsi84: bridge@2c { + compatible = "ti,sn65dsi84"; /* Verdin GPIO_9_DSI (SN65DSI84 IRQ, SODIMM 17, unused) */ /* Verdin GPIO_10_DSI (SODIMM 21) */ enable-gpios = <&gpio3 3 GPIO_ACTIVE_HIGH>; @@ -583,7 +602,7 @@ hdmi_lontium_lt8912: hdmi@48 { compatible = "lontium,lt8912b"; pinctrl-names = "default"; - pinctrl-0 = <&pinctrl_gpio_10_dsi>, <&pinctrl_pwm_3_dsi_hpd_gpio>; + pinctrl-0 = <&pinctrl_gpio_10_dsi>; reg = <0x48>; /* Verdin GPIO_9_DSI (LT8912 INT, SODIMM 17, unused) */ /* Verdin GPIO_10_DSI (SODIMM 21) */ @@ -595,7 +614,7 @@ compatible = "atmel,maxtouch"; /* * Verdin GPIO_9_DSI - * (TOUCH_INT#, SODIMM 17, also routed to SN65DSI83 IRQ albeit currently unused) + * (TOUCH_INT#, SODIMM 17, also routed to SN65DSI84 IRQ albeit currently unused) */ interrupt-parent = <&gpio3>; interrupts = <15 IRQ_TYPE_EDGE_FALLING>; @@ -603,7 +622,7 @@ pinctrl-0 = <&pinctrl_gpio_9_dsi>, <&pinctrl_i2s_2_bclk_touch_reset>; reg = <0x4a>; /* Verdin I2S_2_BCLK (TOUCH_RESET#, SODIMM 42) */ - reset-gpios = <&gpio3 23 GPIO_ACTIVE_HIGH>; + reset-gpios = <&gpio3 23 GPIO_ACTIVE_LOW>; status = "disabled"; }; @@ -638,9 +657,6 @@ assigned-clock-parents = <&clk IMX8MM_SYS_PLL2_50M>, <&clk IMX8MM_SYS_PLL2_250M>; assigned-clock-rates = <10000000>, <250000000>; - clocks = <&clk IMX8MM_CLK_PCIE1_ROOT>, <&clk IMX8MM_CLK_PCIE1_AUX>, - <&clk IMX8MM_CLK_PCIE1_PHY>; - clock-names = "pcie", "pcie_aux", "pcie_bus"; pinctrl-names = "default"; pinctrl-0 = <&pinctrl_pcie0>; /* PCIE_1_RESET# (SODIMM 244) */ @@ -649,6 +665,7 @@ &pcie_phy { clocks = <&clk IMX8MM_CLK_PCIE1_PHY>; + clock-names = "ref"; fsl,clkreq-unsupported; fsl,refclk-pad-mode = <IMX8_PCIE_REFCLK_PAD_OUTPUT>; fsl,tx-deemph-gen1 = <0x2d>; @@ -724,7 +741,6 @@ adp-disable; dr_mode = "otg"; hnp-disable; - over-current-active-low; samsung,picophy-dc-vol-level-adjust = <7>; samsung,picophy-pre-emp-curr-control = <3>; srp-disable; @@ -734,7 +750,6 @@ /* Verdin USB_2 */ &usbotg2 { dr_mode = "host"; - over-current-active-low; samsung,picophy-dc-vol-level-adjust = <7>; samsung,picophy-pre-emp-curr-control = <3>; vbus-supply = <®_usb_otg2_vbus>; @@ -745,6 +760,7 @@ }; &usbphynop2 { + power-domains = <&pgc_otg2>; vcc-supply = <®_vdd_3v3>; }; |