1 files changed, 52 insertions, 0 deletions
diff --git a/tools/testing/selftests/drivers/net/netcons_basic.sh b/tools/testing/selftests/drivers/net/netcons_basic.sh
new file mode 100755
index 000000000000..fe765da498e8
--- /dev/null
+++ b/tools/testing/selftests/drivers/net/netcons_basic.sh
@@ -0,0 +1,52 @@
+#!/usr/bin/env bash
+# SPDX-License-Identifier: GPL-2.0
+
+# This test creates two netdevsim virtual interfaces, assigns one of them (the
+# "destination interface") to a new namespace, and assigns IP addresses to both
+# interfaces.
+#
+# It listens on the destination interface using socat and configures a dynamic
+# target on netconsole, pointing to the destination IP address.
+#
+# Finally, it checks whether the message was received properly on the
+# destination interface.  Note that this test may pollute the kernel log buffer
+# (dmesg) and relies on dynamic configuration and namespaces being configured.
+#
+# Author: Breno Leitao <leitao@debian.org>
+
+set -euo pipefail
+
+SCRIPTDIR=$(dirname "$(readlink -e "${BASH_SOURCE[0]}")")
+
+source "${SCRIPTDIR}"/lib/sh/lib_netcons.sh
+
+modprobe netdevsim 2> /dev/null || true
+modprobe netconsole 2> /dev/null || true
+
+# The content of kmsg will be save to the following file
+OUTPUT_FILE="/tmp/${TARGET}"
+
+# Check for basic system dependency and exit if not found
+check_for_dependencies
+# Set current loglevel to KERN_INFO(6), and default to KERN_NOTICE(5)
+echo "6 5" > /proc/sys/kernel/printk
+# Remove the namespace, interfaces and netconsole target on exit
+trap cleanup EXIT
+# Create one namespace and two interfaces
+set_network
+# Create a dynamic target for netconsole
+create_dynamic_target
+# Set userdata "key" with the "value" value
+set_user_data
+# Listed for netconsole port inside the namespace and destination interface
+listen_port_and_save_to "${OUTPUT_FILE}" &
+# Wait for socat to start and listen to the port.
+wait_local_port_listen "${NAMESPACE}" "${PORT}" udp
+# Send the message
+echo "${MSG}: ${TARGET}" > /dev/kmsg
+# Wait until socat saves the file to disk
+busywait "${BUSYWAIT_TIMEOUT}" test -s "${OUTPUT_FILE}"
+
+# Make sure the message was received in the dst part
+# and exit
+validate_result "${OUTPUT_FILE}"