| Age | Commit message (Collapse) | Author | Files | Lines | |
|---|---|---|---|---|---|
| 2014-04-11 | sync with libdrm 2.4.53 |   jsg | 1 | -1/+23 | |
| 2014-04-10 | marking the isr as MPSAFE snuck in with r1.76. |   dlg | 1 | -2/+2 | |
| while it might be ok (and hasnt actually blown up since i committed that) id rather review the code and enable it explicitely. | |||||
| 2014-04-09 | apparently NVM is a type of mass storage now | dlg | 1 | -1/+2 | |
| 2014-04-09 | sync |   deraadt | 2 | -2/+14 | |
| 2014-04-09 | I have seen a Hitachi ISP2100 in the wild, and next time do not want | deraadt | 1 | -1/+5 | |
| to scan for the product ID again. | |||||
| 2014-04-09 | remove an abstraction that just wraps a straight malloc on attach for | dlg | 1 | -18/+9 | |
| the sc_devs array. | |||||
| 2014-04-09 | some mild knf | dlg | 1 | -12/+31 | |
| 2014-04-07 | Add MSI support for xhci(4). Also add a quirk for some of the Fresco |   brad | 1 | -2/+12 | |
| Logic controllers, taken from the Linux kernel. ok mpi@ | |||||
| 2014-04-07 | - Remove a enumerator for supported sensors, makes better usage of our usb api; |   andre | 1 | -136/+197 | |
| - Allocate/enable sensors wich match both: the static usage table of supported usage IDs and the usages supported by the device; - Do not attach when no sensors can be allocated; - Makes device querying smarter: query the device just once for values stored in the same reportid reply payload. - Use sensor_status. ok mpi@ | |||||
| 2014-04-07 | Use the `use_polling' hack to make sure usb_delay_ms() will not |   mpi | 1 | -1/+5 | |
| call tsleep(9) on resume. deraadt@ pointed that this not needed for powerdown since `cold' is set. Another approach would be to call delay() directly in the reset functions, but let stay coherent with the other HC drivers. | |||||
| 2014-04-07 | regen | brad | 2 | -2/+7 | |
| 2014-04-07 | Add Fresco Logic FL1400. | brad | 1 | -1/+2 | |
| 2014-04-07 | When iterating through fabric ports, start at our own port ID. It doesn't |   jmatthew | 1 | -2/+3 | |
| matter if we don't see ourselves, and if we pick another starting point, the first port we see might disappear half way through (I have seen this happen), which makes it more complicated to identify when we're back at the start. | |||||
| 2014-04-07 | reduce the diff to linux for drm pci vid/pid tests | jsg | 17 | -196/+205 | |
| ok kettenis@ | |||||
| 2014-04-07 | ISP2322 chips need a different firmware image to other 2300s, so until we | jmatthew | 1 | -15/+38 | |
| add that, don't try loading firmware for them. | |||||
| 2014-04-06 | Rework the command polling loop in a similar fashion as was done for qla(4). |   kettenis | 1 | -27/+17 | |
| 2014-04-06 | Clear the interrupt before reading the response queue pointer register in | kettenis | 1 | -3/+4 | |
| the interrupt handler as well. See rev 1.12. | |||||
| 2014-04-05 | set adapter buswidth according to the number of loop ids supported by the | jmatthew | 3 | -10/+13 | |
| firmware (2048 for 2k login firmware, 256 otherwise) pointed out by deraadt@, ok dlg@ | |||||
| 2014-04-04 | Rework the command polling loop so it can handle multiple responses in a single | jmatthew | 1 | -29/+17 | |
| interrupt. With this we can talk to Hitachi disk arrays, which sometimes return so much sense data that a status continuation response is generated in addition to the normal status response. tested by deraadt@ | |||||
| 2014-04-03 | regen |   miod | 2 | -4/+16 | |
| 2014-04-03 | XIRING Ximax CDC adapter | miod | 1 | -1/+5 | |
| 2014-04-03 | Add the missing 6322 PCI id. | brad | 1 | -1/+3 | |
| ok jmatthew@ | |||||
| 2014-04-03 | XHCI -> xHCI to be consistent with device names. | mpi | 1 | -2/+2 | |
| 2014-04-01 | Move some duplicated code implementing Linux compatibility APIs and stick it | kettenis | 4 | -73/+69 | |
| in a seperate header file. This will become a dumping ground for similar code. ok jsg@ | |||||
| 2014-03-31 | Slightly better debugging code. | kettenis | 1 | -15/+16 | |
| 2014-03-31 | Force the detach of all USB devices by disconnecting the root hubs | mpi | 1 | -40/+61 | |
| before suspending the machine. Prior to this commit, devices were logically disconnected after resuming the machine leading to funny races since the controller was reset in between. ok deraadt@ | |||||
| 2014-03-31 | Change the order of operations during a suspend/resume cycle and | mpi | 1 | -3/+4 | |
| call bufq_quiesce() after executing the DVACT_QUIESCE handlers. This should be safe since no disk nor controller drivers have such handler but it will allow us to detach sd(4) devices attached to a USB bus. Another benefit pointed out by kettenis@ is that drivers that need to read a firmware from the disk should be able to do it at resume time in a DVACT_WAKEUP handler. ok kettenis@, deraadt@ | |||||
| 2014-03-31 | Rather than scanning local loop ids sequentially, just ask the chip which | jmatthew | 3 | -18/+75 | |
| local devices it has logged in to. This will also be useful for hotplug later on. | |||||
| 2014-03-31 | qle dvas straddle 4 byte boundaries, so best to treat them as two | dlg | 2 | -9/+21 | |
| u_int32_ts rather than u_int64_ts. ok jmatthew@ | |||||
| 2014-03-31 | the hardware expects ahci_cmd_table to be 128 byte aligned | dlg | 1 | -2/+2 | |
| 2014-03-31 | move the last htoleXX things to htolemXX where possible. | dlg | 1 | -33/+31 | |
| ok jmatthew@ | |||||
| 2014-03-31 | ahci dva things are 64bit and surprisingly aligned nicely to 64bit too. | dlg | 2 | -12/+8 | |
| ok jmatthew@ | |||||
| 2014-03-31 | replace bzero with memset | dlg | 1 | -10/+10 | |
| 2014-03-31 | massage the prdt (what an sgl is on every other chip) loading with | dlg | 2 | -39/+28 | |
| better ops and alignment. ok jmatthew@ who was cruel and made me test hibernate before he oked it. | |||||
| 2014-03-31 | dva on ahci is 64bit | dlg | 1 | -2/+2 | |
| 2014-03-30 | Eliminates struct pcred by moving the real and saved ugids into |   guenther | 1 | -31/+31 | |
| struct ucred; struct process then directly links to the ucred Based on a discussion at c2k10 or so before noting that FreeBSD and NetBSD did this too. ok matthew@ | |||||
| 2014-03-30 | drm/radeon: disable pll sharing for DP on DCE4.1 | jsg | 1 | -2/+16 | |
| From Alex Deucher 2e673e623ba5a604c02fadcad9bf75e6a0ee9705 in ubuntu 3.8 9ef4e1d000a5b335fcebfcf8aef3405e59574c89 in mainline linux | |||||
| 2014-03-30 | drm/radeon: fix missing bo reservation | jsg | 1 | -1/+7 | |
| From Christian Koenig ea0e5ee12a70badcdfee846bfaf5d4338dc285ca in ubuntu 3.8 5e386b574cf7e1593e1296e5b0feea4108ed6ad8 in mainline linux | |||||
| 2014-03-30 | drm/i915/dp: add native aux defer retry limit | jsg | 1 | -5/+12 | |
| From Jani Nikula b4cdadf2591e12c61f895556cf93a8b61a36892c in ubuntu 3.8 f51a44b9a6c4982cc25bfb3727de9bb893621ebc in mainline linux | |||||
| 2014-03-30 | drm/i915/dp: increase native aux defer retry timeout | jsg | 1 | -3/+3 | |
| From Jani Nikula 6048560066737a87621b9169ef4bdab0e3cef620 in ubuntu 3.8 04eada25d1f72efdecd32d702706594f81de65d5 in mainline linux | |||||
| 2014-03-30 | drm/i915: Prevent MI_DISPLAY_FLIP straddling two cachelines on IVB | jsg | 1 | -1/+15 | |
| From Ville Syrjala 0828f7607cee51cabf00b984dad3a8ef200beb41 in ubuntu 3.8 f66fab8e1cd6b3127ba4c5c0d11539fbe1de1e36 in mainline linux | |||||
| 2014-03-30 | drm/i915: Add intel_ring_cachline_align() | jsg | 2 | -2/+24 | |
| From Ville Syrjala 0320c449d2a820ed2a1972e23d8f20f8024a5872 in ubuntu 3.8 753b1ad4a281b0663329409d410243e91825c323 in mainline linux | |||||
| 2014-03-30 | correct the value of DRM_MAJOR for non i386 platforms | jsg | 1 | -1/+5 | |
| ok matthieu@ | |||||
| 2014-03-29 | It's been a quarter century: we can assume volatile is present with that name. | guenther | 4 | -9/+9 | |
| ok dlg@ mpi@ deraadt@ | |||||
| 2014-03-28 | if you split a 64bit thing into two 32bit halves, it helps to write | dlg | 1 | -2/+2 | |
| half of the source value to both the hi and lo parts. writing both of the source halves to just lo isnt going to work good. found by naddy@. sorry guys. | |||||
| 2014-03-28 | Reduce uvm include madness. Use <uvm/uvm_extern.h> instead of | mpi | 8 | -17/+19 | |
| <uvm/uvm.h> if possible and remove double inclusions. ok beck@, mlarkin@, deraadt@ | |||||
| 2014-03-28 | Do not declare a struct as const if we write to it, fix build on sparc64 | mpi | 1 | -2/+2 | |
| reported by brad@. | |||||
| 2014-03-28 | If a command is submitted when the hardware is already gone, it will | mpi | 1 | -7/+7 | |
| obviously time out. That is what happen when pipes are closed after unplugging an xhci(4) express card for example. In such case, make sure the command TRB is reset. | |||||
| 2014-03-28 | specify at least the alignment the hardware requires, and in some cases | dlg | 1 | -16/+16 | |
| the alignment the driver guarantees. with and ok jmatthew@ | |||||
| 2014-03-27 | unbreak mfii after i changed the layout of some structures it borrows | dlg | 1 | -7/+11 | |
| from mpii. disappointment from deraadt@ | |||||
 |
index : wireguard-openbsd | |
| WireGuard implementation for the OpenBSD kernel | Matt Dunwoodie |
| summaryrefslogtreecommitdiffstats |