| Age | Commit message (Expand) | Author | Files | Lines |
|---|
| 2013-01-14 | Fix the sotfware. |   jsing | 1 | -2/+2 |
| 2013-01-06 | acknowlege -> acknowledge |   martynas | 1 | -2/+2 |
| 2012-12-31 | Spell `calculation' correctly. |   miod | 1 | -2/+2 |
| 2012-12-07 | Remove support for waiting for an interrupt within hostcmd_send(), since only |   stsp | 1 | -12/+9 |
| 2012-12-05 | Remove excessive sys/cdefs.h inclusion |   deraadt | 9 | -27/+10 |
| 2012-12-01 | Add RX TCP/UDP checksum offload support. |   brad | 1 | -2/+100 |
| 2012-11-29 | Add rtsx(4), a new driver for the Realtek RTS5209 card reader. | stsp | 3 | -0/+1819 |
| 2012-11-29 | Remove setting an initial assumed baudrate upon driver attach which is not | brad | 4 | -8/+4 |
| 2012-10-27 | Implememnt AP side power saving for acx(4). Tested on acx11. |   claudio | 3 | -19/+66 |
| 2012-10-22 | Add flow control support. | brad | 1 | -7/+22 |
| 2012-10-20 | Init values for the AR9485 were for version 1.0 of this chip, which according | stsp | 6 | -199/+296 |
| 2012-10-20 | Fix hardware kill switch detection for the ar9300 chip family. The driver was | stsp | 4 | -6/+15 |
| 2012-10-19 | Simplify xl_iff_90x() a bit and only check ac->ac_multicnt since ac_multicnt | brad | 1 | -3/+2 |
| 2012-10-17 | Narrow the spltty/splx pair in com_activate to only enclose the minimum | deraadt | 1 | -3/+3 |
| 2012-10-17 | cleanup more of the driver soft-state when suspending; in certain | deraadt | 1 | -5/+14 |
| 2012-10-17 | AH_BYTE_ORDER and AH_BIG_ENDIAN are holdovers from the old FreeBSD |   jsg | 1 | -2/+2 |
| 2012-10-13 | Move WOL activation to DVACT_POWERDOWN (instead of doing it twice, at | deraadt | 1 | -5/+5 |
| 2012-10-12 | Cleanup false positives for uninitialized uses. |   haesbaert | 1 | -1/+2 |
| 2012-10-11 | Enable Host AP power saving support for the RT2700, RT2800 and RT3090 chipsets. |   kettenis | 1 | -3/+1 |
| 2012-10-10 | Avoid potential uninitialized variable access in fxp driver. |   blambert | 1 | -4/+4 |
| 2012-10-04 | Clean up uninitialized warnings from ar9003. | haesbaert | 1 | -3/+3 |
| 2012-09-18 | several tweaks to make mpi(4) work for vmware emulated sas adapters. |   dlg | 1 | -12/+14 |
| 2012-09-12 | Use sg_addr instead of sg_lo_addr, leftovers from last commit. | haesbaert | 1 | -13/+9 |
| 2012-09-12 | Make sure we don't sleep on autoconf. | haesbaert | 2 | -4/+4 |
| 2012-09-04 | The powerlevel is an unsigned int, there is no need to check for negative | claudio | 1 | -2/+2 |
| 2012-08-30 | make a variable that can take a value of -1 signed to match what the | jsg | 1 | -2/+3 |
| 2012-08-26 | htole64 works as good as htole32 twice for dma virtual addresses. | dlg | 2 | -23/+9 |
| 2012-08-25 | Better detection of the st16650 v1 (with the broken fifo). Gets rid of | kettenis | 1 | -2/+5 |
| 2012-08-25 | Turns out the v445 isn't happy at all if we touch the registers that deal | kettenis | 1 | -31/+35 |
| 2012-08-25 | Add support for power saving in Host AP mode. | kettenis | 4 | -5/+73 |
| 2012-08-23 | Fix a race in rt2661 Tx interrupt processing which can cause Tx processing | stsp | 3 | -53/+212 |
| 2012-08-19 | Skip putting a port in sleep mode when it is used as serial console. In that | kettenis | 1 | -17/+19 |
| 2012-08-17 | add support for "physical devices" on skinny controllers. | dlg | 3 | -20/+204 |
| 2012-08-16 | fix mfi_poll by having it do delays between loops, and breaking on | dlg | 1 | -35/+47 |
| 2012-08-16 | rework mfi_poll so it will do all the completions on a ccb including | dlg | 1 | -47/+45 |
| 2012-08-16 | stop passing mfi_softc around as a member of the ccb, consistently give it | dlg | 2 | -40/+34 |
| 2012-08-16 | scrub ccbs when we're about to use them, not when we put them back | dlg | 1 | -8/+16 |
| 2012-08-16 | move the dma syncs for the ccb data into ccb_done, so we can do it once | dlg | 1 | -24/+10 |
| 2012-08-16 | fix up the dma sync for the command frame in mfi_done. | dlg | 1 | -2/+3 |
| 2012-08-15 | Remove the old ioctl interface which has been disabled for over | jsg | 2 | -290/+2 |
| 2012-08-14 | use scsi_get_link to find out the name of a child device for bioctl rather | dlg | 2 | -13/+13 |
| 2012-08-14 | expose the max number of logical volumes the hardware supports as the width | dlg | 2 | -14/+8 |
| 2012-08-14 | print the boards name (eg, perc 5/i) according to the firmware like mfii. | dlg | 1 | -6/+6 |
| 2012-08-14 | gc sc_flags now that the iop struct can tell us where the different IDBs | dlg | 1 | -2/+1 |
| 2012-08-14 | oops, dont claim FUSION is an iop type we will support in mfi(4) | dlg | 1 | -3/+2 |
| 2012-08-14 | move knowledge of the location of the inbound doorbell out of code in | dlg | 2 | -15/+16 |
| 2012-08-13 | get rid of the last foo_lo and foo_hi bits i could find in the hardware | dlg | 2 | -23/+11 |
| 2012-08-13 | do appropriate bus_dmamapy_syncs around the pcq/completion ring. | dlg | 2 | -4/+16 |
| 2012-08-13 | replace uint32_ts for hi and lo addresses in the mfi_init_ hardware | dlg | 2 | -43/+22 |
| 2012-08-11 | the producer/consumer values are used by the device, which is little | dlg | 1 | -4/+4 |
