summaryrefslogtreecommitdiffstats
path: root/sys/netmpls/mpls_input.c (follow)
Commit message (Collapse)AuthorAgeFilesLines
* spellingjsg2021-03-101-2/+2
| | | | ok gnezdo@ semarie@ mpi@
* cleanup unused headers generated by configjsg2020-01-241-3/+1
| | | | ok tedu@ krw@ deraadt@
* fix ipv4 checksum fixup; this trick requires an accumulator of exactly twice the checksum's widthprocter2019-02-081-2/+4
| | | | ok dlg@
* check the result of rtalloc with rtisvalid instead of a compare with NULLdlg2019-01-291-3/+4
| | | | based on advice seen from mpi@
* use mpls_ip_adjttl and mpls_ip6_adjttl in mpe instead of rolling it again.dlg2019-01-271-44/+34
| | | | | | | | mpls_ip_adjttl now patches the checksum rather than check it and calculate it again. both mpls_ip_adjttl and mpls_ip6_adjttl now rely on the caller to check the sysctls for whether they should run or not, which paves the way for making it configurable in mpe via the tunnel ioctls.
* change how packets are pushed into mpe(4).dlg2019-01-271-8/+1
| | | | | | | mpe(4) adds itself ot the mpls rtable with RTF_LOCAL set, which pushes the packet through mpe_output, which sees RTF_LOCAL can calls mpe_input. this follows what mpw(4) does, and removes a special case in mpls_input.
* split off "local" input handlingdlg2019-01-271-1/+27
| | | | | | | | | | this means the current mpls header will be passed along with the mbuf for mpw to look at. right now this doesn't do anything, but it will allow for implementation of RFC 6391 (flow aware transport) and using the exp header for cos. when mpe gets moved to adding an RTF_LOCAL route, this will be used for cos and ttl handling.
* forgot to commit the tweaks to mpls_input when mpw became an ethernet ifacedlg2019-01-271-5/+3
| | | | | | | | | the input mechanism for mpw is now that it inserts a tag into the mpls table with RTF_LOCAL set. mpls_input falls through to calling the interface output routine (mpw_output in this case) which looks for that RTF_LOCAL and then calls mpw_input against that mbuf. ok claudio@ who is keep to apply this semantic to mpe
* check if the incoming ttl is <= 1 before decrementing it.dlg2019-01-261-3/+4
| | | | | | previously it would decrement the uint8_t ttl and then check if it was less than one, which let ttl 0 off the wire wrap to 255 (which is higher than 1).
* Check that mpls has been enabled on the input interface, lost in rev 1.66jca2018-01-121-2/+7
| | | | While here fix under MPLS_DEBUG. ok dlg@
* fix some poop that snuck into the last commit.dlg2018-01-101-3/+5
| | | | noticed by bijanebrahimi at riseup dot net and confirmed by anton@
* make mpls_input take a struct ifnet *ifp argument.dlg2018-01-091-44/+18
| | | | | | | | | | | this makes it like all our other protocol family input functions. mpls_input always looks up the interface the mbuf was received on, but it's always called by code that already has a reference to that interface anyway. the result of this is a few less if_get/if_put calls. ok mpi@ bluhm@ visa@ claudio@
* Pullup the mbuf before accessing the version field in the IP header.bluhm2017-12-081-2/+10
| | | | | Fix the pullup length of the shim header in mpls_do_error(). issue reported by Maxime Villard; OK deraadt@ claudio@
* Use m_freem() in error case. Found by Maxime Villardclaudio2017-12-081-2/+2
| | | | OK bluhm@
* The adjttl functions use m_pullup(). In some cases m_pullup() can returnclaudio2017-12-081-15/+15
| | | | | | | a new mbuf chain and this chain needs to be returned to the caller else a use after free may happen. Issue reported by Maxime Villard OK bluhm@ deraadt@
* mpls_shim_pop() can return NULL. Check it else we end up dereferencing NULL.claudio2017-12-081-1/+7
| | | | | Issue reported by Maxime Villard OK bluhm@ deraadt@
* The per-interface mpls flag should also also be tested on input beforederaadt2017-12-081-14/+24
| | | | | | proceeding, as described in ifconfig documentation. Discussion with claudio. Related to a report from maxime. ok claudio bluhm
* Introduce ipv{4,6}_input(), two wrappers around IP queues.mpi2017-05-301-3/+15
| | | | | | | This will help transitionning to an un-KERNEL_LOCK()ed IP forwarding path. Disucssed with bluhm@, ok claudio@
* Allow MPLS switching and VPLS across rdomains.renato2017-03-021-2/+2
| | | | OK claudio@ mpi@
* Retire the AF_MPLS protosw struct. Nothing is using it and the code was superclaudio2017-02-271-6/+1
| | | | | | | basic anyway. Simplifies the code a lot also by calling the mpls sysctl no longer via the protosw but instead directly. OK mpi@ on a previous diff. Also tested by renato@ who actually found a bug which is now fixed.
* Do not dereference ``rt->rt_ifa'' after calling rtfree(9).mpi2016-08-221-2/+3
| | | | | | | This could result in a use after free if the route entry was holding the last reference of the address descriptor. ok jca@, bluhm@, claudio@
* Revert the introduction of ``rt_addr''.mpi2016-07-111-2/+2
| | | | | | Being able to add route entries without configured addresses is a nice feature but this is not my fight. So I'd rather no add another pointer to ``struct rtentry'' if I'm not removing another one.
* Store the source address associated with a route in its own chunk ofmpi2016-06-141-2/+2
| | | | | | | | | memory. This will allow to unlink 'sruct rtentry' and 'struct ifaddr' to be able to add route entries without needing an address. ok sthen@, visa@, florian@
* There is no need to grab the KERNEL_LOCK here anymore. After discussion withclaudio2015-12-041-7/+1
| | | | dlg@ and mpi@
* Oups, forgot in the tedu of RT_REPORT commitclaudio2015-12-021-3/+3
|
* Rework the MPLS handling. Remove the lookup loops since nothing is usingclaudio2015-12-021-163/+116
| | | | | | | | | them and they make everything so much harder with no gain. Remove the ifp argument from mpls_input since it is not needed. On the input side the lookup side is modified a bit when it comes to BOS handling. Tested in a L3VPN setup with ldpd and bgpd. Commiting now so we can move on with cleaning up rt_ifp usage. If this breaks L2VPN I will fix it once reported. OK mpi@
* rtfree(9) and rtalloc(9) no longer need to be called under KERNEL_LOCK.mpi2015-10-231-20/+7
|
* Always increment rt_use inside rtalloc(9) instead of doing it in somempi2015-09-231-3/+1
| | | | | | specific places. ok claudio@, benno@
* There's no point in abstracting ifp->if_output() as long as pf_test()mpi2015-09-131-2/+2
| | | | | | needs to see lo0 in the output path. ok claudio@
* Stop overwriting the rt_ifp pointer of RTF_LOCAL routes with lo0ifp.mpi2015-09-121-2/+2
| | | | | | | | | Use instead the RTF_LOCAL flag to loop local traffic back to the corresponding protocol queue. With this change rt_ifp is now always the same as rt_ifa->ifa_ifp. ok claudio@
* Don't use mpls_input() as input handler anymore and instead call itrzalamena2015-07-291-50/+24
| | | | | | directly. Also protect non mp-safe functions while at it. ok mpi@.
* Implemented MPLS pseudowire (mpw(4)) to be used with VPLS and VPWS.rzalamena2015-07-201-1/+6
| | | | ok mpi@, claudio@.
* Kill NETISR_MPLS, from now on we will use interface input handlers to dealrzalamena2015-07-201-21/+45
| | | | | | with MPLS packets. ok mpi@, claudio@
* Store a unique ID, an interface index, rather than a pointer to thempi2015-06-161-3/+4
| | | | | | | | | | | | | | | receiving interface in the packet header of every mbuf. The interface pointer should now be retrieved when necessary with if_get(). If a NULL pointer is returned by if_get(), the interface has probably been destroy/removed and the mbuf should be freed. Such mechanism will simplify garbage collection of mbufs and limit problems with dangling ifp pointers. Tested by jmatthew@ and krw@, discussed with many. ok mikeb@, bluhm@, dlg@
* replace the use of ifqueues for most input queues serviced by netisrdlg2015-04-101-28/+9
| | | | | | | | | | | | | | | | | with niqueues. this change is so big because there's a lot of code that takes pointers to different input queues (eg, ether_input picks between ipv4, ipv6, pppoe, arp, and mpls input queues) and falls through to code to enqueue packets against the pointer. if i changed only one of the input queues id have to add sepearate code paths, one for ifqueues and one for niqueues in each of these places by flipping all these input queues at once i can keep the currently common code common. testing by mpi@ sthen@ and rafael zalamena ok mpi@ sthen@ claudio@ henning@
* unifdef some more INET. v4 4life.tedu2014-12-231-6/+1
|
* Explicitly include <net/if_var.h> instead of pulling it in <net/if.h>.mpi2014-12-051-1/+2
| | | | ok mikeb@, krw@, bluhm@, tedu@
* Rename rtalloc1() into rtalloc(9) and convert its flags to only enablempi2014-11-011-3/+3
| | | | | | functionnality instead of a mix of enable/disable. ok bluhm@, jca@
* Use rtfree() instead of RTFREE(), NULLify some free'd route pointers andmpi2014-10-141-5/+5
| | | | | | kill the macro. ok mikeb@, henning@
* Fewer <netinet/in_systm.h> !mpi2014-07-221-2/+1
|
* Remove the number of in6_var.h inclusions by moving some functions andmpi2013-10-241-3/+1
| | | | | | global variables to in6.h. ok deraadt@
* The header file netinet/in_var.h included netinet6/in6_var.h. Thisbluhm2013-10-171-1/+2
| | | | | | | created a bunch of useless dependencies. Remove this implicit inclusion and do an explicit #include <netinet6/in6_var.h> when it is needed. OK mpi@ henning@
* Keep this copy of the ICMP checksum code in sync with recent changes.mpi2013-07-101-7/+4
| | | | ok lteo@, claudio@, bluhm@, henning@
* Move various extern declarations into their corresponding header file.mpi2013-04-241-2/+1
|
* Remove various read-only *maxlen variables and use IFQ_MAXLEN directly.mpi2013-03-261-3/+2
| | | | ok beck@, mikeb@
* cosnistently use IFQ_SET_MAXLEN, surfaced in a discussion with + ok bluhmhenning2011-07-061-2/+2
|
* make mpls compile w/o errors when inet6 is not definedmikeb2011-01-211-1/+15
| | | | | diff from form@ who's too busy drinking vodka with pelmeni to commit this; ok claudio
* Handle IMPLNULL labels (#3) directly in the kernel like we do with theclaudio2010-10-071-6/+21
| | | | | explicit NULL labels. IMPLNULL labels should never ever be seen on the wire but we're realists. michele@ agrees
* First shot at ICMP error handling inside an MPLS path. Currently onlyclaudio2010-09-131-16/+118
| | | | | | TTL exceeded errors for IPv4 are handled. This makes traceroute through MPLS tunnels work (including RFC 4950 MPLS extension header). "best to get it in." deraadt@
* Use correct function name in panic()claudio2010-07-071-2/+2
|
Copyright © 1996 – 2023 Jason A. Donenfeld. All Rights Reverse Engineered.